Incorporated standards are available for inspection at the Office of Manufactured Housing Program, Manufactured Housing and Construction Standards Division, U.S. These incorporated standards are available for purchase from the organization that developed the standard at the corresponding addresses noted below. If a later edition is to be enforced, the Department will publish a notification of change in the Federal Register. The incorporation by reference of these standards has been approved by the Director of the Federal Register. 552(a) and 1 CFR part 51 as though set forth in full. (a ) The specifications, standards, and codes of the following organizations are incorporated by reference in 24 CFR part 3280 (this Standard) pursuant to 5 U.S.C. Nothing in this definition should be interpreted to mean that a manufactured home necessarily meets the requirements of HUD's Minimum Property Standards (HUD Handbook 4900.1) or that it is automatically eligible for financing under 12 U.S.C. These dimensions will include all expandable rooms, cabinets, and other projections containing interior space, but do not include bay windows. Calculations used to determine the number of square feet in a structure will include the total of square feet for each transportable section comprising the completed structure and will be based on the structure's exterior dimensions measured at the largest horizontal projections when erected on site. The term does not include any self-propelled recreational vehicle.
This term includes all structures that meet the above requirements except the size requirements and with respect to which the manufacturer voluntarily files a certification pursuant to § 3282.13 of this chapter and complies with the construction and safety standards set forth in this part 3280. Manufactured home means a structure, transportable in one or more sections, which in the traveling mode is 8 body feet or more in width or 40 body feet or more in length or which when erected on-site is 320 or more square feet, and which is built on a permanent chassis and designed to be used as a dwelling with or without a permanent foundation when connected to the required utilities, and includes the plumbing, heating, air-conditioning, and electrical systems contained in the structure. Specific requirements for designing the transportation system.Īttached Manufactured Homes and Special Construction ConsiderationsĪttached manufactured home unit separation. General requirements for designing the structure to withstand transportation shock and vibration. Outdoor outlets, fixtures, air-conditioning equipment, etc. Wiring of expandable units and dual units. Heating, Cooling and Fuel Burning SystemsĮxhaust duct system and provisions for the future installation of a clothes dryer.ĭisconnecting means and branch-circuit protective equipment. Heat loss, heat gain and cooling load calculations.Ĭomfort cooling certificate and information.
Quality control testing, manuals, facilities, and personnel.Ĭondensation control and installation of vapor retarders. Standard for swinging exterior passage doors for use in manufactured homes.Īir chamber test methods for certification and continuing qualification of formaldehyde emission levels.
#ZONE 2 MOBILE HOME WIND RATING WINDOWS#
Standard for egress windows and devices for use in manufactured homes. Requirements for windows, sliding glass doors, and skylights. Requirements for foam plastic thermal insulating materials.įactory constructed or site-built attached garages.įactory constructed or site-built attached carports.įormaldehyde emission controls for composite wood products Requirements for thermal insulating materials.
#ZONE 2 MOBILE HOME WIND RATING MANUAL#
Manufactured home procedural and enforcement regulations, and consumer manual requirements.Įxit facilities egress windows and devices.įlame spread limitations and fire protection requirements. Manufactured Home Construction and Safety Standards
0 kommentar(er)
